Steam-raising plant and boilers Figure 1 shows a sectional view of a typical steam-raising boiler. This is known as a shell and tube boiler and is the most common type. The hot gases from the burner go through the furnace tube and then back through the smoke
Read More
Straight tube, shell-and-tube waste heat boilers frequently develop tube and tube sheet failures due to the imposition of unequal stresses. A primary cause of this is the uneven distribution of hot gases across the face of the tube sheet. The tubes involved tend to come loose, creating leakage problems.
Read More
The high powered Clayton Steam generator is the world's most compact, efficient, responsive and safest way of producing high quality steam. The Clayton Steam generator has been continually developed since 1930 and is very different from the traditional firetube boiler design that is the familiar steam train boiler image of the past.
Read More
This steam trap is therefore acting mostly as a "steam cooler" wasting steam from the Steam Main. Note the nice insulation job however; this is probably keeping the problem from being much worse. Condensate should always be drained from the BOTTOM of the steam line in low sections of pipe and at changes in direction, such as a 90 Degree turn.
Read More
Firebox (steam engine) The firedoor into the firebox of a steam locomotive. The firebox peak temperature is approximately 2,500 °F (1,370 °C) For other uses, see Firebox (disambiguation). In a steam engine, the firebox is the area where the fuel is burned, producing heat to boil the water in the boiler. Most are somewhat box-shaped, hence the
Read More
Steam-raising plant and boilers Figure 1 shows a sectional view of a typical steam-raising boiler. This is known as a shell and tube boiler and is the most common type. The hot gases from the burner go through the furnace tube and then back through the smoke
Read More
Straight tube, shell-and-tube waste heat boilers frequently develop tube and tube sheet failures due to the imposition of unequal stresses. A primary cause of this is the uneven distribution of hot gases across the face of the tube sheet. The tubes involved tend to come loose, creating leakage problems.
Read More
h1: The ratio enthalpy of steam (kJ/kg) The initial value of boiler efficiency for Z Boiler is depending on the boiler type, but it is normally 80-88%. In short, 80-88% in the generated heating value after the fuel is burnt by the burner regenerates into the steam
Read More
GENERATORS – Problems & Remedies 1) The generator will NOT DELIVER any current 1a) Alternator de-energised - Re-energise 1b) After re-energising, the generator still does NOT DELIVER any current - Replace the condenser and repeat the re-energising
Read More
2. BOILERS Bureau of Energy Efficiency 27 Syllabus Boilers: Types, Combustion in boilers, Performances evaluation, Analysis of losses, Feed water treatment, Blow down, Energy conservation opportunities. 2.1 Introduction A boiler is an enclosed vessel that provides a means for …
Read MoreCopyright © 2021.Boiler All Rights Reserved.
